Table of Contents
Advertisement
G7 Installation & Operation
System log: This log file is designed in programming language for
troubleshooting and some useful running information will be record into this file.
If you meet a problem with the receiver, please click the download button to
download this log file and provide it to ComNav support team.
User log: This log file is designed to record running status information in user
language to make the user understand what happen in the receiver. The
information type can be selected in this page.
Firmware update: This submenu is designed for firmware update, when you
receive a new firmware for the receiver, please click the Browser button to
select the proper firmware file and clock the confirm button to make the update.
It takes about two or three minutes to install the update. For the latest firmware
resource, please consult your local ComNav dealer.
GNSS registration: A kind of registration mechanism is designed for the
receiver. If the registration code expires, you will lose control over the receiver
and data output will stopped. If your receiver expires, please provide the SN
number to ComNav support team to get help for registration.
Work mode setup
The G7 receiver supports several work modes such as Rover UHF, Rover
NTRIP and Base Int. UHF. The desired work mode can be setup from the PC
or the smartphone webpage.
This chapter will demonstrate the smart phone version of the webpage.
UHF Rover Settings
In this mode, the G7 is configured as a rover and receives correction data via
the UHF radio. Note that the setting of this mode using the computer is
different from the smartphone version.
Smartphone version
1. Connect your smartphone to the receiver's WiFi and login to the webpage
2. Select the "RTK work mode" menu as shown in Figure 23. Click "Change work mode"
at the bottom of the page, and select "RTK work mode" as "Auto Rover", "Data link" as
"Rover UHF".
Document PN 29010107 V1r1
- 56 -
Advertisement
Table of Contents
