Table of Contents
Advertisement
G7 Installation & Operation
Appendices
Appendix 1
Logging Data
This chapter outlines how to log data from the G7. This operation can be performed by
streaming the data from the G7 to a PC via Bluetooth or serial cable.
The steps to stream and save data to a PC is as follows:
Configure the G7 to output NMEA messages via Bluetooth or serial communication
1. Power up the G7, and make sure it is operating normally.
2. Connect your PC's WiFi to the G7 WiFi and log in
3. To connect via Bluetooth, go to IO setting as shown in Figure 38 below, then select Bluetooth and set the
NMEA messages desired. By default, the NMEA messages are turned off. Select the NMEA message
and click on confirm to save the changes.
4. To connect via serial cable (A_RS232) go to IO setting as shown in Figure 39 below, then select Serial
port and set the NMEA messages desired. By default, the NMEA messages are turned off. Select the
NMEA message and the baud rate (in the Figure 39 the GPGGA sentence is set to an update rate of 10
Hz and the baud rate is set to 115200), Click on confirm to save the changes.
Document PN 29010107 V1r1
Figure 38 – Set Bluetooth NMEA messages.
- 73 -
Advertisement
Table of Contents
