Table 18 - Troubleshoot The G7 - ComNav G7 Installation & Operation Manual

G7 Installation & Operation
The receiver is
not responding.
The receiver is
not receiving
satellite signals
Document PN 29010107 V1r1
Faulty power
cable. Check that you are using the correct
cable for the connection between power
port and power supply.
Check that the correct external power
supply is connected to a particular
power port.
Check pinouts with a multimeter to
ensure internal wiring is intact.
Receiver needs Turn off the receiver and then turn it
a soft reset. back on again.
The GNSS Make sure that the GNSS antenna cable
antenna cable is tightly seated in the antenna
is loose. connector on the GNSS antenna.
The cable is Check the cable for any signs of
damaged damage. A damaged cable can inhibit
signal detection from the antenna at the
receiver.
The GNSS
Make sure that the GNSS antenna is
antenna is not
located with a clear view of the sky.
in clear line of
sight to the sky.
Restart the receiver as a last resort (turn
off and then turn it on again).
Table 18 – Troubleshoot the G7.
- 83 -