Table of Contents
Advertisement
G7 Installation & Operation
For the "Auto Base" mode, this mode is enabled by clicking the "Save" button,
the receiver will broadcast correction data based on the coordinate which is
obtained through autonomous positioning automatically.
For the "Manual Base" mode, the "Reference Latitude", "Reference Longitude"
and "Reference Height" can be entered manually or use the "Acquire Current
Position" button to get the data automatically. After that click "Save" button to
make the changes effective.
For Sample for Average:
Users can determine the positioning limit and sampling amount. The positioning
limit falls into two types:
a) Single Solution Coordinates: Collect the coordinates of receiver obtained
through autonomous positioning.
b) Fixed Solution Coordinates: Only collect coordinates of receiver with a
fixed solution.
After the configuration of positioning limit and sampling amount, click
carry out sampling and averaging → the progress bar will show the progress →
the result will be used as the coordinate of current position. If users need to
save the changes, please tap
3. Go to "Module setting" menu, then click "Radio setting". The operation about radio
setting is same as in Rover UHF mode.
Document PN 29010107 V1r1
Figure 33 – Auto base and manual base settings.
button.
- 64 -
to
Advertisement
Table of Contents
