Table of Contents
Advertisement
G7 Installation & Operation
2. After ten seconds, the power LED will still be on showing a solid red color
and the three other LEDs will be off.
3. The status LED will flash twice per second in yellow color.
4. The Bluetooth and WiFi for the receiver can be searched and connected
to.
5. The satellite LED will flash in blue color if the GNSS antennas have been
connected to the receiver.
Operation
This chapter describes the operation for setting up the G7 receiver using the
web interface. This includes configuring the receiver work mode, data output
setup as well other settings.
Please make sure the receiver is powered on and running normally before
modifying the settings.
Quick start
After connecting the antennas and cables, power on the receiver. Once the
receiver is running, connect to it using WiFi to configure and monitor the
receiver settings. No cable connection to the receiver is required. Please follow
the following steps to get started connecting to the receiver's webpage via WiFi.
1. Using the WiFi connection application on your PC or smartphone, find the access
point SSID of the receiver. Search the WiFi network named as GNSSXXXXXXX
(where XXXXXXX represents the SN of your receiver) on your computer or
smartphone, and then establish the connection (See Figure 18 as an example)
Document PN 29010107 V1r1
- 45 -
Advertisement
Table of Contents
