Table of Contents
Advertisement
G7 Installation & Operation
1. Make sure the base station is configured and the correction data is
transmitting by the UHF radio.
2. Check the radio antenna connection to the receiver, and make sure it is
installed properly.
3. Set and check the radio parameters in the webpage to make sure all of
the parameters you set for the receiver matches those set for the base
station's radio settings.
4. Check the receiver's LED status to monitor the correction data
transmission status.
5. Check the receiver's built-in webpage for the position status.
Rover NTRIP/IP
The Rover NTRIP work mode has the receiver working in rover mode and uses
the built-in 4G network module to receive correction data from CORS server.
The available SIM card service and proper account for CORS service are
necessary for this work mode. Please install the SIM card properly before you
power on the receiver.
This section will be demonstrates using the smartphone and PC versions.
Smart phone version
1. Connect your smartphone to the receiver's WiFi and login to the webpage.
2. Select the "Module" menu and click on the "GPRS" submenu, turn on the "GPRS
Model Status" if it is closed and "Auto Start" status bar also needs to be turned on.
The next step is to turn on the "Dialing Connect" and "Auto Connect". Type proper
network parameter for "APN", "Dialing String", "User Name" and "Password". After
that click "Confirm" button to make the settings effective.
Document PN 29010107 V1r1
- 59 -
Advertisement
Table of Contents
