Table of Contents
Advertisement
G7 Installation & Operation
Note that it is not necessary to connect all the accessories as shown in Figure
10 as this depends on the specific project requirements. For example, if the
receiver is not working in radio mode, the radio antenna will not be required.
GNSS Antenna cable
The receiver has two TNC-type male connectors for connecting to the GNSS
antennas. The receiver is intended for use with two ComNav Geodetic GNSS
antennas. Connect the antenna to the TNC plug socket of the receiver via the
GNSS antenna cable as shown in Figure 11. Please note the following tips:
1. Locate the correct two connectors for the GNSS antennas.
2. Choose the proper length of the GNSS antenna cable according to your
application, the standard length of this cable is 5 meters.
3. Make sure the connectors at the receiver and antenna ends are both
tightened.
Document PN 29010107 V1r1
Figure 10 – Fully connected G7.
- 39 -
Advertisement
Table of Contents
