Table of Contents
Advertisement
G7 Installation & Operation
Reference
station
settings
Receiver
reset
1PPS
settings
Antenna configuration: This page is used to make configure the antenna,
such as antenna type, elevation mask.
Reference station setting: Three kinds of modes are supported, namely, Auto
rover, Auto base and Manual base.
Receiver reset: This submenu supports four different settings for the receiver.
The reboot receiver means restart the receiver system without power off. The
reset to default means makes the receiver operate in default settings with
default configuration file. Clear satellite data is used to make the receiver
recapture the satellites and this operation needs several minutes to get enough
satellites to get the position information. Turn off receiver used to power off the
receiver from software side and cut the power off in hardware.
1PPS settings: This submenu is used to enable or disable the PPS signal
output. By default, the PPS signal is always enabled.
IO settings
The IO settings is used to enable the following settings as shown in Figure 22.
RTK client: to enable the G7 to receive correction from a CORS station
TCP client/server: To send or receive corrections from via TCP/IP protocol
Serial Port: Enables G7 to send NMEA messages to a PC serial port and set
Document PN 29010107 V1r1
Table 9 – Receiver configuration options.
- 51 -
Advertisement
Table of Contents
