Table of Contents
Advertisement
G7 Installation & Operation
For this work mode, the receiver works with both both the SIM card and CORS
services to get better accuracy for the position. Please follow the following tips
to ensure optimal operation
1. Make sure the SIM card is in good condition and the network service is
not stopped by the supplier.
2. Make sure the 4G antenna is installed properly. Sometimes, because of
the weak signal, the dialing process will fail.
3. Make sure your CORS account and password is correct to get the RTK
service.
4. Choose the proper RTK source from the list after you got it.
5. Check the receiver's LED status to monitor the correction data
transmission status when all the operations are done.
Base Int. UHF
This work mode is similar to the Rover UHF mode case, the major difference is
that the receiver works as a base station and correction data is sent by the
radio. This section will be illustrated using the smartphone and webpage
versions.
Smart phone version
1. Connect your smartphone to the receiver's WiFi and login.
2. Select the "RTK work mode" menu into the setting page, click "Change work mode" at
the bottom of the page, select "RTK work mode" as "Auto Base" or "Manual Base",
"Data link" as "Base Int. UHF".
Note that there is a difference between "Auto Base" and "Manual Base".
Document PN 29010107 V1r1
Figure 31 – RTK client setting using NTRIP.
- 62 -
Advertisement
Table of Contents
