Punch Unit B531 (Option); Punch Position Adjustment; Front To Rear Adjustment; Right To Left Adjustment - Ricoh B064 Service Manual

Hide thumbs Also See for B064:

Table of Contents

3.8 PUNCH UNIT B531 (OPTION)

The position of the punched holes can be adjusted in two ways.

Three spacers [A] are provided with the punch unit for manual adjustment of the

hole position in the main scan direction:

NOTE: One spacer was installed at installation and the remaining spacers were

fastened with a screw to the rear frame of the finisher under the rear cover

and slightly above the lock bar.

The position of the punched holes can be adjusted right to left in the sub scan

direction with SP6-113 Punch Hole Adjustment. The position can be adjusted in the

range ±7.5 mm in 0.5 mm steps. The default setting is 0.

Press the  key to toggle the ± selection. A larger value shifts the punch holes

left toward the edge of the paper, and a smaller value shifts the holes right away

from the edge.

PUNCH UNIT B531 (OPTION)

B531R101.WMF

Table of Contents