Ricoh B064 Service Manual page 740

COPY IMAGE ADJUSTMENTS: PRINTING/SCANNING
3.14 COPY IMAGE ADJUSTMENTS: PRINTING/SCANNING
These adjustments must be performed after replacing any of the following parts:
• Scanner wires
• Lens block
• Scanner motor
• Polygon motor
• Tandem tray side fences
• Memory All Clear
3.14.1 PRINTING
1. Make sure paper is installed correctly in each paper tray before you start these
adjustments.
⇒
2. Use the Trimming Area Pattern (SP2-902-3, No. 18 to print the test pattern for
the following procedures.
3. After completing these printing adjustments, be sure to set SP 2-902-3 to 0
again.
Registration - Leading Edge/Side-to-Side
1. Check the leading edge registration, and adjust it using SP1-001.
Specification: 3 ± 2mm.
2. Check side-to-side registration for each paper feed station, and adjust with the
following SP modes.
Tray 1 (Tandem Tray)
Tray 2 (Universal Tray)
Tray 3 (Universal Tray)
Tray 4
By-pass Tray
LCT
Duplex Tray
B064/B065
SP mode Specification
SP1002 001
SP1002 002 0±1.5
SP1002 003
SP1002 004 Japan Only
SP1002 005
0±1.5
SP1002 006
0±1.5
SP1002 007
0±1.5
3-126
Rev. 07/2002
B
A
B064R946.WMF
SM