Ricoh B064 Service Manual page 811

IEEE1394 (G336) FIREWIRE INTERFACE
⇒
1.13.3 UP MODE SETTINGS FOR IEEE 1394
Enter the UP mode and follow the procedure below to perform the initial interface
settings for IEEE 1394. These settings take effect every time the machine is
powered on.
1. Press User Tools/Counter.
2. On the touch panel, press System Settings.
3. Press Interface Settings.
System Intialization Settings
Select the desired settings.
Network
4. Press the key and enter the following settings:
• IP Address
• Subnet Mask
• IP Over 1394. Enable or disable this setting as required. This setting enables
IP Over 1394 as the default setting for the printing method.
• SCSI Print. Enable or disable this setting as required. This setting enables
SCSI Print as the default setting for the printing method.
• SCSI Print Bi-directional. Switch bi-directional printing on or off for SCSI print.
B064/B065
Parallel Interface IEEE 1394
IP Address 0000.0000.0000.0000
Subnet Mask 0000.0000.0000.0000
IP Over 1394 Enabled
SCSI Print Enabled
IEEE 802.1b
SCSI Print Bi-directional
1-54
Rev.10/2002
End
On
B064I998.WMF
SM