Ricoh B064 Service Manual page 829

Hide thumbs Also See for B064:

Table of Contents

Tech Service Bulletin No. B064/B065 – 013

PRODUCTION COUNTERMEASURE

The spacers and cushion will be installed at the factory during production from the following serial numbers

listed below.

B064: J4225800853

B065: J4325800494

Each authorized servicing location will receive and automatic allocation of Damper Kits for 100% of the

affected population.

DAMPER KIT INSTALLATION PROCEDURE:

1. Turn the drum flange [A] clockwise until the cam [B] reaches the position as shown.

2. Add one spacer [C] to the release camshaft, only if there is 1 spacer already installed (1 e-ring [D]).

If there are two spacers already installed, skip this step.

3. Remove the screw [E].

4. Apply grease G501 [F] to the release cam.

5. Attach the cushion [G] using the new M4x14 hexagonal screw [H].

To ensure the screw does not rattle or come loose, be sure to tighten it at a 90-degree angle (not

Chapters

Table of Contents