Ricoh B064 Service Manual page 858

Hide thumbs Also See for B064:

Table of Contents

BULLETIN NUMBER:

APPLICABLE MODEL

GESTETNER – 6002/7502

LANIER – LD060/LD075

RICOH – AFICIO 1060/1075

SAVIN – 2560/2575

SUBJECT: TROUBLESHOOTING PAPER FEED JAMS

The following procedure has been created for troubleshooting paper feed jams. Please perform this

procedure if jams have been logged in any of the following SP Modes: SP7504 - 3, 4, 5, 8, 9, 10, 12,

53,54, 55, 58, 59, or 60. The illustration on page 3 has been changed. The gears in which the arrow

position and cutout position match are OK, and those that do not match are NG.

1. If a paper jam occurs with an infrequently used tray. (e.g. By-pass Tray):

If the surface color of the pick-up, feed or separation rollers is lighter than those installed in more

commonly used trays, replace the roller(s).

2. If noise is generated from the paper feed unit:

Adjust the timing belt tension as follows:

(1) Remove the paper feed unit.

(2) Loosen screw [A] and move the motor toward the tray. (See photograph below)

TECHNICAL SERVICE BULLETIN

B064/B065 – 018 REISSUE

→ → → → Tray side

Continued....

Chapters

Table of Contents