Ricoh B064 Service Manual page 303

SP Number/Name
1008* Duplex Fence Adjustment
1103* Fusing Idling
1104* Fusing Temperature Control
1105* Fusing Temperature Adjustment
001 Normal
003 OHP
005 Thick Paper
1106 Fusing Temperature Display
1112 Auto Process Control
1901* CPM Down Setting for Special Paper
001 Thick Paper
002 Tab Sheet
SM
SERVICE PROGRAM MODE TABLES
Function/[Setting]
Adjusts the distance between front and rear
fences. A smaller value shortens the distance.
If the fences are too far apart, skewing may
occur in the duplex tray. If the fences are too
close, the paper may be creased in the duplex
unit.
[–4~+4/0/0.1 mm]
Adjusts the fusing idling time.
[0~900/70/1 s]
Increase this value when fusing on the 1st and
2nd copies is incomplete due to low room
temperature.
Selects the fusing temperature control mode.
Off: On/Off control
On: Phase control
If power supply to the machine is unstable,
select Phase Control. The machine must be
switched off and on after this setting is
changed for the new setting to take effect.
Phase control could interfere with radio or TV
reception.
Adjusts the fusing temperature of the hot roller
for plain paper, OHP or thick paper.
[170~200/185/1 degree C]
[170~200/165/1 degree C]
[170~200/195/1 degree C]
Displays the temperature of the hot roller
detected by the thermistors.
Sets the temperature of the hot roller for auto
process control to start.
ο ο ο ο
[70 ~150 /140 /1 C] DFU
Selects the speed (copies per minute) for
copying on thick paper or tab sheets. A slower
speed ensures better fusing.
[0~4/2/1 step]
0: 25 cpm
1: 35 cpm
2: 40 cpm
3: 45 cpm
4: 55 cpm
This setting does not affect fusing
temperature.
5-23 B064/B065