Service Tables - Ricoh B064 Service Manual

5. SERVICE TABLES


CAUTION
Never turn off the main power switch when the power LED is lit or flashing.
To avoid damaging the hard disk or memory, press the operation power
switch to switch the power off, wait for the power LED to go off, and then
switch the main power switch off.
5.1 SERVICE PROGRAM MODE
5.1.1 SERVICE PROGRAM MODE OPERATION
The service program mode is used to check electrical data, change modes, and
adjust values. Two service program modes are provided:
• SP Mode (Service). Includes all the options in the SP displays for normal
maintenance and adjustments.
• SSP Mode (Special Service). Includes the normal SP modes and some
additional options in the SP displays not required for normal settings and
adjustments. (These SP numbers are in bold type and most are marked "DFU"
(Design or Factory Use) in the tables.) Do not change these settings needlessly.
Entering and Exiting SP mode

1. Press the Clear Mode key.
 2. Use the keypad to enter "107".
 3.
4. Enter the Service Mode.
Copy SP
 Copy SP
Exit 5. Press Exit to return to the copy window.
To Switch to the Copy Window for Test Printing
1. In the SP mode display, press Copy Window to switch to the copy operation
screen when you need to select paper for a test print.
2. Use the copy window (copier mode) to select the appropriate settings (paper
size, etc.) for the test print.
3. Press Start  to execute the test print.
4. Press SP Mode (highlighted) to return to the SP mode screen and repeat from
step 1.
SM
Hold down Clear/Stop for at least 3 seconds.
The Copy SP or PM Counter items are displayed. The
Printer SP and Scanner SP are also available if installed.
To enter the Normal Service Mode:
On the touch-panel, press Copy SP.
To enter the Special Service Mode:
Hold down  and then press Copy SP.
5-1
SERVICE PROGRAM MODE
B064/B065