SMC Networks 100BASE-TX Management Manual page 279

Command Usage
This command provides information on the community access strings, counter
information for SNMP input and output protocol data units, and whether or not
SNMP logging has been enabled with the snmp-server enable traps
command.
Example
Console#show snmp
System Contact: Joe
System Location: Room 23
SNMP traps:
Authentication: enabled
Link-up-down:
SNMP communities:
1. private, and the privilege is read-write
2. public, and the privilege is read-only
0 SNMP packets input
0 Bad SNMP version errors
0 Unknown community name
0 Illegal operation for community name supplied
0 Encoding errors
0 Number of requested variables
0 Number of altered variables
0 Get-request PDUs
0 Get-next PDUs
0 Set-request PDUs
0 SNMP packets output
0 Too big errors
0 No such name errors
0 Bad values errors
0 General errors
0 Response PDUs
0 Trap PDUs
SNMP logging: disabled
Console#
enabled
4
SNMP Commands
4-103