Rate Limit Configuration; Figure 3-50. Output Rate Limit Port Configuration - SMC Networks 100BASE-TX Management Manual

Rate Limit Configuration

Use the rate limit configuration pages to apply rate limiting.
Command Usage
• Input and output rate limit can be enabled or disabled for individual interfaces.
Command Attributes
• Port/Trunk – Displays the port number.
• Rate Limit Status – Enables or disables the rate limit. (Default: Disabled)
• Rate Limit Level – Sets the rate limit level. (Range: 1-30: Default: 30)
Note:
Actual rate limit = Rate Limit Level * Granularity
Web – Click Port, Rate Limit, Input/Output Port/Trunk Configuration. Enable the
Rate Limit Status for the required interfaces, set the Rate Limit Level, and click
Apply.

Figure 3-50. Output Rate Limit Port Configuration

CLI - This example sets the rate limit level for input and output traffic passing
through port 3.
Console(config)#interface ethernet 1/3
Console(config-if)#rate-limit input level 25
Console(config-if)#rate-limit output level 25
Console(config-if)#
3
Port Configuration
4-104
4-117
4-117
3-81