Show Logging; Table 4-19. Show Logging Flash/Ram - Display Description - SMC Networks 100BASE-TX Management Manual

4
Command Line Interface

show logging

This command displays the logging configuration.
Syntax
show logging {flash | ram | trap}
• flash - Event history stored in flash memory (i.e., permanent memory).
• ram - Event history stored in temporary RAM (i.e., memory flushed on
power reset).
• trap - Displays settings for the trap function.
Default Setting
None
Command Mode
Privileged Exec
Example
The following example shows that system logging is enabled, the message level for
flash memory is "errors" (i.e., default level 3 - 0), the message level for RAM is
"debugging" (i.e., default level 7 - 0).
Console#show logging flash
Syslog logging:
History logging in FLASH: level errors
Console#show logging ram
Syslog logging:
History logging in RAM: level debugging
Console#
Field
Syslog logging
History logging in FLASH The message level(s) reported based on the logging history command.
History logging in RAM
4-48
Enabled
Enabled

Table 4-19. show logging flash/ram - display description

Description
Shows if system logging has been enabled via the logging on command.
The message level(s) reported based on the logging history command.