Mac Acls; Access-List Mac; Table 4-35. Mac Acls - SMC Networks 100BASE-TX Management Manual

MAC ACLs

Command

access-list mac

permit, deny
show mac access-list
mac access-group
show mac access-group
map access-list mac
show map access-list
mac
access-list mac
This command adds a MAC access list and enters MAC ACL configuration mode.
Use the no form to remove the specified ACL.
Syntax
[no] access-list mac acl_name
acl_name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• When you create a new ACL or enter configuration mode for an existing ACL,
use the permit or deny command to add new rules to the bottom of the list.
To create an ACL, you must add at least one rule to the list.
• To remove a rule, use the no permit or no deny command followed by the
exact text of a previously configured rule.
• An ACL can contain up to 32 rules.
Example
Console(config)#access-list mac jerry
Console(config-mac-acl)#

Table 4-35. MAC ACLs

Function
Creates a MAC ACL and enters configuration mode
Filters packets matching a specified source and
destination address, packet format, and Ethernet type
Displays the rules for configured MAC ACLs
Adds a port to a MAC ACL
Shows port assignments for MAC ACLs
Sets the CoS value and corresponding output queue for
packets matching an ACL rule
Shows CoS value mapped to an access list for an interface PE
Access Control List Commands
Mode
GC
MAC-ACL
PE
IC
PE
IC
4
Page
4-93
4-94
4-95
4-95
4-96
4-96
4-97
4-93