Figure 3-72. Port Priority Configuration - SMC Networks 100BASE-TX Management Manual

Web – Click Priority, Default Port Priority or Default Trunk Priority. Modify the default
priority for any interface, then click Apply.
CLI – This example assigns a default priority of 5 to port 3.
Console(config)#interface ethernet 1/3
Console(config-if)#switchport priority default 5
Console(config-if)#end
Console#show interfaces switchport ethernet 1/3
Information of Eth 1/3
Broadcast threshold:
LACP status:
Ingress rate limit: disable, Level: 30
Egress rate limit: disable, Level: 30
VLAN membership mode:
Ingress rule:
Acceptable frame type:
Native VLAN:
Priority for untagged traffic: 5
GVRP status:
Allowed VLAN:
Forbidden VLAN:
Private-VLAN mode:
Private-VLAN host-association: NONE
Private-VLAN mapping:
Console#

Figure 3-72. Port Priority Configuration

Disabled
Disabled
Hybrid
Enabled
Tagged frames only
1
Disabled
1(u),
NONE
NONE
Class of Service Configuration
3
4-104
4-165
4-113
3-121