Converting To A Different Type Of Gas - Henny Penny SmartCombi GSC62 series Planning And Installation Instructions

Gas
1
1
1
2
1
40

6.2 Converting to a different type of gas

NOTICE
When converting to a different type of gas, the burner orifice must be
changed. The orifices, together with an orifice table, are in a plastic bag
located in the connection compartment.
1. Switch the unit off at the mains (switch off circuit breakers or remove
the plug) and shut off the central gas supply.
2. Remove the fixing screws at the bottom of the unit on the left.
3. Remove the side panel.
With floor standing units: remove one screw at the top and one at the
bottom.
With tabletop units: remove two screws at the bottom and two in the
middle.
4. Remove the fixing screws for the gas valve.
5. Remove the gas valve.
6. Remove gas orifice with seal (1).
7. Select orifice according to the orifice table and refit it using an
undamaged seal (2).
8. Mount the gas valve and screw it tightly.
9. Reopen the central gas supply.
10. Start the unit.
11. Switch the power supply back on.
After the type of gas has been converted, you can proceed with the leak
test, the connection pressure test and the calibration of the CO
values.
Planning and installation instructions
Smart Combi
™
Classic Combi
™
/CO
2
Global Foodservice Solutions