Entering into the environment setup mode
Press 'SET' button of the ACP to enter into the environment setup mode of the ACP.
When the 'SET' button is pressed for the first time, the menu to set the IP address is displayed
as shown below.
Press up/down(▲, ▼) button to place the arrow on the desired function.
When you select [Network Info] and press "SET" button, it enters the No. 1 menu in the following fig-
In [Network Info] menu, input the network information such as IP address of the ACP.
When you select [Contents] and press "SET" button, it enters the No. 2 menu in the following figure.
In [Contents] menu, you can set the functions of the ACP and select language to use.
When you select [Function] and press "SET" button, it enters the No. 3 menu in the following figure.
In [Function] menu, ACP software service function is supported.
• [Function] menu is used by the system air conditioner service technician, so user shall
never use this function.
If this function is incorrectly used, it may cause disorder of the ACP.
CH6 USAGE is not shown in [Contents] menu for Standard.