Offline Operation Using Digsi 5 - Siemens SIPROTEC 5 Operation Manual

Operation in the Operating State
8.3 Operation Options
Adding a Selected Device to a Project
You can accept devices identified online into an existing project. The devices are also available for possible
offline operation. You can accept the devices in 2 ways:
Use Drag & Drop to assign the online device to the corresponding device created in a project.
²
NOTE
i
i
Make sure that the created device coincides with the device identified online. Otherwise, it is not accepted
into the project.
If you have not done so yet, add the online device to the opened project (see following image) via the
²
context menu (right mouse-click).
[scprohin-210211-01.tif, 1, en_US]
Figure 8-3

Offline Operation Using DIGSI 5

8.3.3
Offline operation offers you the ability to carry out complete configurations and extensive parameterization of
a device. Once you have finished all settings, you can load the complete parameter set from the DIGSI 5 PC to
the device. If the loading operation was successful, the device restarts automatically.
Typical Applications of Offline Configuration
Creating a parameter set by selecting a suitable application template and subsequently adjusting the
²
settings to the individual conditions
Reusing a standardized parameter set in several devices
²
Extensive changes in configurations and setting parameters
²
NOTE
i
i
For a device to be editable offline, you must first have created it in a project. After successful loading of the
parameter set, the device restarts automatically.
Procedure
From the project tree, select the project where the device to be controlled was created.
²
Select the respective device within the project.
²
110
Adding Selected Device to a Project
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-7, Edition 06.2016