Operational Log - Siemens SIPROTEC 5 Operation Manual

•
The routing of the selected indication is done via right click. Select one of the options in the list box
shown:
– Routed (X)
– Unrouted
[scinfpuf-191012-01, 1, en_US]
Figure 8-8
For non-configurable logs (for example, setting-history logs) scope and type of logged indications are
described separately (see following chapter about logs).
8.4.5.2

Operational Log

Operational indications are information that the device generates during operation. This includes information
about:
•
State of device functions
•
Measured data
•
Power-system data
Exceeding or dropping below limiting values is output as an operational indication. Short circuits in the
network are indicated as an operational indication Fault with sequential fault number. For detailed informa-
tion about the recording of system incidents, please refer to the description of the fault log (chapter
8.4.5.3 Fault Log
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-7, Edition 06.2016
Indication Configuration in DIGSI 5 (Example: Ground-Fault Log)
). Up to 2000 indications can be stored in the log.
Operation in the Operating State
8.4 Indications
119