Setting And Resetting Energy Values - Siemens SIPROTEC 5 Operation Manual

•
Circuit breaker (function group)
– Fundamental component/symmetrical components
– Displaying available measured values (reduced scope against
– Function measured values (protection-specific measured values)
– Displaying available measured values (reduced scope, for example measured values of the
synchro-check function)
– Statistical values
– User-defined measured values
b) Reading Measured Values with DIGSI 5
•
Establish an online connection to the device.
•
In the online menu (bottom left in the project tree), open Measured values.
•
Double-click the respective function group and the measured value view appears in the operating range.
•
Select the respective tab of the desired measured value group.
Arrangement of the groups follows the ordering principle in the
measured-value view. You can further select whether the measured values are shown to you as primary,
secondary or percentage values. Furthermore, you have the possibility of saving the measured values.
•
If you wish to save the measured values, click the Snapshot button in the menu bar.
You can read the saved measured values of the device in offline mode in the Process data folder, Measured-
value snapshots menu.
[scmswesi-080413-01.tif, 1, en_US]
Figure 8-35

Setting and Resetting Energy Values

8.5.3
Setting and resetting energy values on the device:
To set and reset on the device use the Measured values menu.
²
In the corresponding function group, mark the Energy measured values.
²
You can reset the energy values using the right context-sensitive Reset key on the display.
²
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-7, Edition 06.2016
Example of Measured-Value View in DIGSI 5
Operation in the Operating State
8.5 Edit Measured and Metered Values
Table 8-7)
Table 8-7. Figure 8-35 shows an example of a
143