Siemens SIPROTEC 5 Operation Manual page 146

Operation in the Operating State
8.5 Edit Measured and Metered Values
You can set the statistical values to the desired value via the right context-sensitive Change key. The
²
input value is converted to the data format according to IEC 61850. In addition, the input value is
rounded to 6 digits. The display is limited to 6 digits. Therefore please note that, in case of small pulse
weighting, minor changes to large metered values can not be reflected in the display.
Set the new value and activate acceptance with Enter.
²
Setting and resetting statistical values with DIGSI 5:
Start the online mode with DIGSI 5.
²
Click (in the project tree bottom left) the Measured values menu item.
²
Double-click the Circuit breaker function group and the measured-value window appears in the oper-
²
ating range.
If you open the Statistics tab in the measured-values window, you are shown the current statistical
²
values (see
You can reset the current values to 0 by clicking the Reset button.
²
Alternatively, you can set a value:
Enter the desired value in the Current value column. The input value is converted to the data format
²
according to IEC 61850. In addition, the input value is rounded to 6 digits. The display is limited to 6
digits. Therefore please note that, in case of small pulse weighting, minor changes to large metered
values can not be reflected in the display.
To transfer the value to the device, click the Set button.
²
[scubstwe-080413-01.tif, 1, en_US]
Figure 8-37
146
Figure 8-37).
Overview of Statistical Values
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-7, Edition 06.2016