Siemens SIPROTEC 5 Operation Manual page 196

Maintenance, On-the-Spot Assistance and Test
9.4 Firmware and Parameter Set Update
[scupgwrn-220813-01, 1, en_US]
Figure 9-11
Finally, you must load the updated parameter set to the device. Proceed as follows:
Select the device in the project tree.
²
Right-click to open the context menu .
²
Select the Load configuration to device entry.
²
[scupgpa2-130913-01, 2, en_US]
Figure 9-12
Enter the confirmation ID.
²
After the data have been transferred successfully, the device will restart.
196
Errors and Warnings From Updating
Transferring the Parameter Set
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-7, Edition 06.2016