Siemens SIPROTEC 5 Operation Manual page 135

NOTE
i
i
If the device executes an initial start, for example, after an update of the device software, the following
logs are automatically deleted:
•
Operational log
•
Fault log
•
Ground-fault log
•
Setting-history log
•
User log
•
Motor-startup log
Back up the deletable logs using DIGSI 5.
NOTE
i
i
If a ground fault is currently active, the ground-fault log cannot be deleted.
Deleting Logs on the On-Site Operation Panel
•
To reach the selected log from the main menu, use the navigation keys of the on-site operation panel
(example operational log):
Main Menu → Indications → Operational log
[scoprlog-090413-01.tif, 1, en_US]
Figure 8-28
•
You can navigate within the displayed indication list using the navigation keys (up/down) on the on-site
operation panel.
•
The option to delete the entire log is offered to you in the footer of the display at the bottom left. Use the
softkeys below under the display to activate the command prompts. Confirm the request to Delete.
•
After being prompted, enter the password and confirm with Enter.
•
After being prompted, confirm the Deletion of all entries with Ok.
Deleting Logs from the PC with DIGSI 5
•
To reach the selected log of your SIPROTEC 5 device, use the project-tree window (for example, opera-
tional log).
Project → Device → Process data → Logs → Operational log
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-7, Edition 06.2016
Deleting the Operational Log on the On-Site Operation Panel
Operation in the Operating State
8.4 Indications
135