Siemens SIPROTEC 5 Operation Manual page 80

Using DIGSI 5
6.4 Transferring Device Data from the PC to the Device
NOTE
i
i
If you wish to use another Ethernet interface port other than port J, in Device Information select the inter-
face with which DIGSI 5 should communicate with your SIPROTEC 5 device.
Alternatively, you can select the following path for the setting of the Ethernet address.
[scipruec-030311-01.tif, 1, en_US]
Figure 6-3
Connect, for example, the Ethernet port J on the rear of the SIPROTEC 5 base module to the engineering
²
PC using a suitable Ethernet cable.
In the project tree of your DIGSI 5 project, double-click the Devices and networks menu item.
²
You will find all devices of your project with the offline configurations in the Device view tab. Select the
²
device with which you would like to connect and click the Ethernet port of the displayed device (see
Figure 6-3).
Enter the IP address, subnet mask and optionally the IP address of a router (standard gateway).
²
In the project tree of your DIGSI 5 project, double-click the Load configuration in devices menu item.
²
Execute this in the corresponding offline configuration of the device.
DIGSI 5 recognizes automatically that the device is connected via Ethernet. The loading of the configuration
from the DIGSI 5 project to the device is then initiated.
NOTE
i
i
If you wish to use another Ethernet interface port other than port J, in Device information select the inter-
face with which DIGSI 5 should communicate with your SIPROTEC 5 device.
80
Rear panel of a SIPROTEC 5 device
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-7, Edition 06.2016