Paper Jams - Lexmark MX310 Service Manual

Sensor (narrow media) jam service check
Action
Step 1
Check the narrow media sensor for jammed media fragments.
Is the paper path free of partially fed or jammed media?
Step 2
Check the narrow media sensor cable JNRW1 for proper
connection.
Is it properly connected?
Step 3
POR into the Diagnostics menu and perform a sensor test:
Diagnostics Menu > Base Sensor Test > Narrow Media
Does the sensor state on the control panel display change when
it is toggled?
Step 4
Does the error remain?

202 paper jams

202 paper jam messages
Error code Description
202.01 Exit sensor is covered during warm up.
202.03 Media did not reach the fuser exit sensor.
202.05 Fuser exit sensor covered too long by the current
sheet.
202.07 Fuser exit sensor covered too long by the
previous sheet.
202.13 Restart attempted after an internal jam without
cover open. Close event. Likely that the jam was
not actually cleared.
202.16 Page at fuser nip before fuser started ramping
toward desired. Indicates code may be receiving
more hall interrupts than intended.
202.17 Page at fuser nip before fuser reached acceptable
operating temperature. Page arrived at fuser
earlier than expected, so it was probably staged.
Action
Go to
page
Go to
page
Go to
page
Go to
page
Go to
page
Go to
page
Go to
page
Diagnostics and troubleshooting
104
Yes No
Go to step 2. Clear the paper path
of any media
fragments.
Go to step 3. Reseat the cable.
Go to step 4. Replace the narrow
media sensor.
Contact the next The problem is
level of support. solved.
"Sensor (fuser exit) jam service check" on
105.
"Sensor (fuser exit) jam service check" on
105.
"Sensor (fuser exit) jam service check" on
105.
"Sensor (fuser exit) jam service check" on
105.
"Sensor (fuser exit) jam service check" on
105.
"Sensor (fuser exit) jam service check" on
105.
"Sensor (fuser exit) jam service check" on
105.
7015