Fuser Removal - Lexmark MX310 Service Manual

8
If necessary, remove the bushing (B) from the redrive assembly.
Installation note: Install the bushing (A) on the redrive assembly before installing the shaft.

Fuser removal

1
Remove the left cover. See
2
Remove the rear door and cover. See
on page 370.
3
Remove the redrive assembly. See
4
Disconnect the cable JEXIT1 from the controller board.
5
Disconnect the two cables (A).
"Left cover removal" on page
"Rear exit door removal" on page 369
"Redrive assembly removal" on page
Parts removal
375
279.
and
372.
7015
"Rear cover removal"