Trailing Edge Sensor Removal - Lexmark MX310 Service Manual

c
Apply the RheoGel 739 to the lower edge (B) where the wiper bracket glides.

Trailing edge sensor removal

1
Remove the left cover. See
2
Remove the right cover. See
3
Remove the rear door and cover. See
on page 370.
4
Remove the power supply. See
5
Remove the power supply shield. See
6
Remove the duplex. See
7
Position the printer so that it sits on its left side.
8
Disconnect the cable JACM1 from the controller board.
9
Release the retainer spring (A) from the bracket (B).
10
Remove the screw (C).
"Left cover removal" on page
"Right cover removal" on page
"Rear exit door removal" on page 369
"Power supply removal" on page
"Power supply shield removal" on page
"Duplex removal" on page
A
Parts removal
279.
294.
339.
341.
B C
350
7015
and "Rear cover removal"
340.