Register The Inverter In Ingecon Sun Monitor; Updating The Inverter Firmware - Ingeteam INGECON SUN 3TL Installation And Operation Manual

Ingeteam
1. Open the web application from the device's browser.
2. Open Comms in the top menu.
3. Select Ethernet in the left panel.
4. Click on the option Change in the Primary field.
5. In the IP Mode field, select the Fixed or DHCP option.
6. If you have selected Fixed, complete the required data (IP address, IP mask and IP gateway).
INFO
To verify that the gateway and network mask are correct, access the network settings properties of a device that
is on the same network or request it from the network administrator.
7. Finally click on Send.
A window will appear with the data of the new IP address setup.

12.7. Register the inverter in INGECON SUN Monitor

INGECON SUN Monitor is an application for monitoring photovoltaic installations. It is also available as a web
application.
To register the inverter in INGECON SUN Monitor, there is a label attached to the inverter that indicates the Device
ID and password (Register at www.ingeconsunmonitor.com).
INFO
The inverter should be registered via the web application at www.ingeconsunmonitor.com.

12.8. Updating the inverter firmware

INFO
To perform this procedure, the inverter must be connected to the Internet through a Wi-Fi network or Ethernet.
1. Open the web application from the device's browser (see
2. Open the Update menu. If there are any updates available they will be listed.
3. Install the update.
This operation can also be done using the button in the control application.
44
"12.4. Connecting to the inverter
ACL2011IQM01_ - Installation and Operation Manual
Using the unit
remotely").