Printing With The Serial-To-Parallel Adapter - AEMC 1060 User Manual

CONTINUITY TEST
OBJECT: 01 .....................................TEST: 02
Date: ............................................03.31.2001
Start time: .............................................14:55
Continuity: ............................................0.91Ω
INSULATION RESISTANCE TEST
OBJECT: 01 .....................................TEST: 03
Date: ............................................03.31.2001
Start time: .............................................14:55
Test duration: .......................... 15 min 30 sec
Temperature: ................................°C .........°F
Relative humidity: ....................................... %
Test voltage: ...................................... 1000 V
Insulation resistance (IR): ................. 385 GΩ
DAR (RI 1'/30"): ....................................1.234
PI (RI 10'/RI 1'): ....................................2.345
Comments: .....................................................
........................................................................
........................................................................
A space for the operator's signature is available at the end of the printout.

5.6 Printing with the Serial-to-Parallel Adapter

• Connect the null - modem RS-232 cable to the Model 1060.
• Connect the cable to the adapter, then the adapter to the printer cable.
• Turn on the printer.
• Turn on the Model 1060.
• To start printing out values that haven't been saved (immediate printing),
press PRINT after a measurement.
• To start printing out saved measurements, press the PRINT MEM button
WARNING: This adapter is designed exclusively for use with the Model 1060 and
is not suitable for any other application.
38
Megohmmeter Models 1050 /1060