AEMC 1060 User Manual page 52

To run a timed test, perform the following steps:
Select the appropriate voltage for the test by clicking on the radio button next
1.
to the desired selection.
Press the Start button. This will run the test at the selected voltage.
2.
As the test is running, all other buttons are grayed out and the Start button
becomes a Stop button.
Once the test has started, a graph will begin to appear and build on the right side
of the Control Panel (see Figure 7-8).
The statistical data for the time of the test, DAR, PI, resistance value and other
information will appear as they are completed on the lower left side of the Control
Panel.
The test will stop automatically at the end of the programmed run time. You may
also stop the test at any time by pressing the Stop button.
Once the test has been completed press the Save to Disk button to save the
3.
results of the test just completed to a disk drive in your computer.
Name the file, then press the Save button.
4.
50
Figure 7-8
Megohmmeter Models 1050 /1060