Using Dataview - AEMC 1060 User Manual

7.4 Using DataView

Once the serial connection between the computer and the Model 1060 has been
completed, as described above, start DataView
There are two ways to open and use the DataView
Using the Megohmmeter Icon
• Double-click the Megohmmeter Icon that was created during installation,
located on the desktop.
• DataView
®
(see Figure 7-6).
Using the DataView Icon
• Double-click the DataView Icon that was created during installation,
located on the desktop.
• DataView
®
(see Figure 7-5).
• Click the Configure Instrument button and the Connection window will
appear (see Figure 7-6).
46
®
will open and the Connection window will appear
will open and display the DataView Quick Start window
Figure 7-5
® .
software:
®
Megohmmeter Models 1050 /1060