Running The Test - AEMC 1060 User Manual

• Clear Memory: Erases all contents in all memory locations in the mego-
hmmeter.
• Download: Retrieves the stored data from all memory locations within
the megohmmeter for naming and storing on the computer's disk drive
memory.
Once all fields in the Setup dialog box have been configured, it is recommended
that you perform the following steps.
Click on the Save button
1.
Name and save the file.
2.
Click on the Write button to configure the megohmmeter with this new con-
3.
figuration.
Click on the Close button to exit Setup and open the Control Panel.
4.
NOTE: While connected, both the DataView
open. They have similar main menu options, so you need to be aware of which
window you are working in.
You can tell which window you are working in by looking at the top left corner
of the active window. It will either display "DataView" or "Megohmmeter".
You can select the Megohmmeter Control Panel via the Windows taskbar at the
bottom of your screen.
7.4.2

Running the Test

After configuring the instrument (see § 7.6.1), the Control Panel will automatically
open. The Control Panel is used to initiate a timed test from the computer.
The Control Panel dialog box consists of five command buttons:
• Start: This button begins a timed test.
• Clear Display: Clears the statistical data, on the lower left side of the
screen, and the graph, on the right side of the screen.
• Save to Disk: Saves the current data to a file in the computer.
• Configure: Returns to the megohmmeter Setup dialog box for configur-
ing the instrument.
• Download: Retrieves data from the memory of the megohmmeter for
storage in the computer.
Megohmmeter Models 1050 /1060
®
and Megohmmeter windows are
49