Printing Measured Values; Instantaneous Printing Of Measurements - AEMC 5050 User Manual

■ The V/TIME button gives access to the date/time/V/OBJ-TEST number for
each result.
■ If the recording selected by the OBJ : TEST number corresponds to a time-
controlled test, the R(t) values can be accessed by pressing the R(t) button.
The small display changes and indicates min:sec (time of 1st sample) and the
symbol flashes on the screen. You can scroll through the other samples
with the button.
To exit from R(t) mode and return to the normal memory recall mode (OBJ :
TEST), press R(t) or R-DAR-PI-DD again.
To exit the MR function, press the MR button again or turn the selector switch.

5.3 PRINTING MEASURED VALUES

(Not Available for Model 5060 with USB Port)
If you use a serial printer, choose the appropriate communication speed (baud
rate) in the SET-UP menu between 300 - 9600 baud. Then, program the printer
to the format run by the instrument (see §5.1).
There are two printing modes possible:
■ Instantaneous printing of measurement (PRINT).
■ Printing of recorded data (PRINT memory).
NOTE: If the data transmission to the printer is successful, the COM
symbol will flash once on the screen. If a problem has occurred, the
COM symbol will remain on the LCD screen without flashing.

5.4 INSTANTANEOUS PRINTING OF MEASUREMENTS

(Not Available for Model 5060 with USB Port)
Following a measurement or after accessing values in MR mode, use the PRINT
function to print the measurement results.
NOTE: PRINT only works when the test is stopped by pressing the
START/STOP button and the value is displayed on the LCD.
Press the PRINT button to print the following:
■ 1 set of measurements (V/R/DAR/PI/DD/date/time) for normal tests.
■ The R(t) values if the "time-controlled test" has been used.
To stop printing, move the position of the selector switch.
Megohmmeter Models 5050 & 5060
33