Digital Display Features; Bargraph - AEMC 1060 User Manual

• - Decreases the flashing parameter being displayed. To move
about the list of interval insulation measurements in the R(t) function.
If the and
eters is increased to a faster rate.
Model 1060 only:
• MEM - Saves measured values
• MR - Recalls saved data
• PRINT - Prints measurement results
• PRINT MEM - Prints memory contents
6. AC power plug (direct operation on AC and battery recharge).
7. RS-232 serial interface male plug (9-pin) for connection to a PC or printer.

2.2 Digital Display Features

Main Display Indicates:
• Insulation measurement (resistance, DAR and PI, capacitance)
• Continuity measurement
• Resistance measurement
Small Display Indicates:
• Voltage measured or applied by the instrument
• Elapsed time or the output voltage, during insulation measurement
After recording data (1060), the small display also indicates the time and date in MR
(memory recall) mode, and the memory address with the OBJ : TEST number.

2.3 Bargraph

• Active during insulation measurement (0.1MΩ to 1TΩ).
• Indicates the battery charge at start-up.
• Indicates free memory space - one segment representing approximately
100 groups of saved values, with each group holding approximately 50
recordings (1 OBJ and 1 TEST).
10
buttons are held down, the movement between param-
Megohmmeter Models 1050 /1060