Connecting The Model 1060 To Your Computer - AEMC 1060 User Manual

12. When the drivers are finished installing, the Installation Successful dialog
box will appear. Click on OK.
13. Next, the Installation Wizard Complete window will appear. Click on Fin-
ish.
14. A Question dialog box appears next. Click Yes to read the procedure for con-
necting the instrument to the USB port on the computer.
NOTE: The Set-up window remains open. You may now select another option to
download (e.g. Adobe
15. Restart your computer, then connect the instrument to the USB port on the
computer.
16. Once connected, the Found New Hardware dialog box will appear. Windows
will complete the driver installation process automatically.
Shortcuts for DataView
installation process have been added to your desktop.
NOTE: If you connected your instrument to the computer before installing the
software and drivers, you may need to use the Add/Remove Hardware utility to
remove the instrument driver before repeating the process.

7.3 Connecting the Model 1060 to your Computer

The Model 1060 is supplied with a serial interface cable necessary for connecting
the instrument to the computer. This cable (Cat. #2119.45) is equipped with a 9-pin
female connector on each end, thus providing the ability to interface with comput-
ers that have 9-pin connectors (see diagram in § 5.1).
To connect the megohmmeter to your computer:
• Connect the 9-pin connector from one end of the cable to the serial port
on the front panel of the Model 1060 megohmmeter.
• Connect the 9-pin from the other end of the cable to an available serial
port on the back of your computer.
You are now ready to communicate using the DataView
megohmmeter.
Megohmmeter Models 1050 /1060
® Reader), or close the window.
and each instrument control panel selected during the
®
software with the
®
45