Temperature Measurement; Measurement Without External Sensor; Measurement With External Sensor - AEMC 601 User Manual

3.12 TEMPERATURE MEASUREMENT

3.12.1 Measurement without External Sensor

1. Set the switch to
The temperature (blinking) displayed is the internal temperature of the device. It
will be equal to the ambient temperature after a sufficiently long thermal
stabilization time (at least one hour).

3.12.2 Measurement with External Sensor

The device measures the temperature using a K-thermocouple.
1. Connect the K-thermocouple to the COM and "+" input terminals of the
device observing the red and black banana plug polarity.
2. Set the switch to
3. Place the K-thermocouple on the element or environment to be
measured. It must not be at a dangerous voltage.
The temperature will be displayed on the screen.
To change the unit to either °F or °C, press the
NOTE:
- If the external sensor is defective, the temperature displayed blinks.
- If there are large variations of the initial temperature environment of the
meter and the measurement environment, the measurement must be
preceded by a stabilization time.
.
.
27
(yellow) button.