Canon imageRUNNER iR2270 Service Manual page 79

Chapter 3
3.3.1.3 Removing the
Upper Cover
1) Remove the screw [1] on the back of the
finisher and detach the top cover (rear) [2].
[2]
F-3-84
2) Disconnect the 2 connectors [1] and then
remove the harness from the upper cover
[2].
F-3-85
3-26
0008-0733
[1]
3) Remove the 3 screws [1] and detach the
upper cover [2].
F-3-86
3.3.1.4 Removing the
Bottom Cover
1) Remove the screw [1] and detach the
bottom cover (lower) [2].
2) Remove the screw [3] and remove the
catch [4] and pin [5].
3) Remove the 2 screws [6] and detach the
bottom cover [8] while pulling up the lever
[7].
[1]
0008-0738