Canon imageRUNNER iR2270 Service Manual page 46

Delayed feed Inlet sensor (PI5)
jam (1011)
Staying paper
jam (1121)
Staple jam Stapler HP sensor
(1506) (built in stapler)
Stack ejection Stack slider HP
jam (1F08) sensor (PI1)
The paper ejected from the
host machine is not fed to
the finisher within the
specified time.
Paper stayed in the paper
ejection path longer than the
specified time.
The stapler does not operate
normally because it is
bloced with a staple.
Paper ejection error or stack
slider HP return error.
Chapter 2
The inlet sensor is not
turned on within the
specified time after
reception of a paper
ejection signal from the
host machine.
The inlet sensor is not
turned off even if paper
is fed by the specified
distance after the
leading edge of the
paper from the host
machine has passed
through the sensor.
The stapler HP sensor
was turned off once
after start of stapler
operation, but the HP
has not been reached
within the specified
time.
When a paper stack is
ejected, the HP sensor
is not turned off within
the specified time.
2-25