Chapter 3
connectors [2], and then remove the stapler
[3].
[1]
[3]
[2]
F-3-209
3.4.11.6 Removing the
Drive Unit
1) Disconnect all connectors from the
finisher controller PCB [1].
2) Remove the 2 screws [2] and remove the
finisher controller PCB together with the
mount [3].
[2]
[3]
[1]
F-3-210
3) Detach the timing belt [1].
3-62
F-3-211
4) Remove the 4 screws [1] and remove the
drive unit [2].
0008-1083
F-3-212
3.4.11.7 Removing the
1) Remove the 2 screws [1] and remove the
inlet guide [2].
[2]
[1]
Process Tray Unit
[1]
[1
0008-1084