Rev 3.0B Feb.08
&Dn
Set DTR mode.
n=0 : Ignore DTR, same effect as HW DTR always asserted
•
(same as S211=1).
•
n=2 : Use hardware DTR (same as S211=0).
&Sn
Set DSR mode.
•
n=0 : Always assert DSR (Default).
•
n=1 : Assert DSR when in a data mode (UDP, TCP, PPP, or
SLIP) (Default).
•
n=2 : Assert DSR when the modem has network coverage.
Tip: S211 can also be used to request that DSR is always asserted. If
S211 is set to 3 and &S is changed to a non-zero value, S211 will be
changed to 1.
\APPP
Set modem operation to PPP mode. Cannot be configured in
AceManager.\ASLIP
Set modem operation to SLIP mode. DTR must be asserted
(&D0 or S211=1). Cannot be configured in AceManager.
\Qn
Set or query the serial port flow control setting.
•
n=0 : No flow control is being used.
•
n=1 : RTS/CTS hardware flow control is being used.
•
n=4 : Transparent software flow control. Uses escaped
XON and XOFF for flow control. XON and XOFF
characters in data stream are escaped with the @ character
(0x40). @ in data is sent as @@.
+IPR=n
I/O Port Rate: Sets the data rate for the serial port (DTE‐DCE).
C3x11 or C3x11E only. Default is 115200. Cannot be configured
in AceManager.
•
n=port rate (45 | 50 | 75 | 110 | 300 | 600 | 1200 | 2400 |
4800 | 9600 | 19200 | 38400 | 57600 | 115200 | 230400)
$QCVAD=n
Mode for answering data or fax with the A (answer) or via
auto answer (S0=1). C3x10 or C3x10E only. Cannot be
configured in AceManager.
Configuration Commands
105