Connecting Power Supply Cables; Powering On Ipvt10 - Grandstream Networks IPVT10 Administration Manual

Connecting Power Supply cables

IPVT10 only supports AC power supply, users can connect the two power supply cables following the steps below:
1. Connect the standard power supply cable with the equipment.
2. Plug the power supply into the AC power supply.
3. Repeat steps "1" and "2" to connect the second power supply cable.
Note
Please use the standard three-phase power outlet.
Please make sure that the output voltage is within the range of the power module (90~264VAC, 8.5~2.7A, 50/60Hz). If it is
not within the working range, correct it and do not power on the equipment.

Powering on IPVT10

Before powering on the equipment, users need to ensure that the equipment meets the following conditions:
If the equipment is installed in a cabinet, please ensure that the screws are fixed, and the equipment has enough space
for heat dissipation.
The connections of the cables on the equipment are normal.
The input power and current are within the working range of the equipment.
The distance between the power cable and the Ethernet cable outside the cabinet must be greater than 30 mm.
Once the previous conditions are checked, the users can power up the IPVT10 Server. To make the equipment run properly,
users need to press the equipment switch in the front panel of the server to power on the equipment. The indicator will turn
to solid green.
After the equipment is turned on, please check the following indicators to make sure the equipment is working properly.
NO
Name
.
1 Power Indicator
2 Hard Disk Indicator
Figure 4: Connecting Ethernet Cables to Ethernet Interfaces
Figure 5: IPVT10 powered on
Description
When the equipment is ON and connected to the power supply: the light is solid
green
When the equipment is OFF and the power supply is not connected with the
equipment: the light is off
When the hard disk is running normally: the light is off.
When the hard disk is reading and writing: the light is solid blue.