Install Operator - Assa Abloy Norton 6011 Series Installation Instructions Manual

6011/6051 Series (Pull Side) Power Operator

Install Operator

A. Secure Backplate.
1. Secure backplate to frame using six (6):
1/4-20 x 5/8" machine screws or
1/4 x 1-1/2" self-drilling screws. (Figure 7)
NOTE: It is important to properly secure
top edge of backplate. Use of blocking
(supplied by others) or shims (provided) to
fill gap between backplate and wall above
OR
header is HIGHLY recommended. Material
must comply with local codes. Failure to
properly secure top of backplate could result
in operator being allowed to 'rock' during
operation. This could result in damage to
operator and diminish operator function.
(Figure 7)
B. Install End Caps.
1. Secure end caps to each end of backplate using
four (4) (two each) #8-32 x 5/16" Phillips pan
head screws. (Figure 8)
NOTE: Orient end caps so that text on labels is
legible when observed from ground.
Copyright © 2019, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9360-1026-020 Rev 4 11/19
Blocking
Figure 7
Figure 8
7