Table of Contents
Advertisement
Installation instructions
3.8 Adjusting the air flow in the drying zone
The air flow through the machine is dependent on a number of factors, e.g.:
•
•
•
•
•
As many different factors affect the air flow through the machine, for best results
each machine must be adjusted according to the conditions that apply in the case
in question. When the machine is set so that the air flow is balanced, there will be
no leakage of steam from the machine's infeed or outfeed. All steam will then be
evacuated via the heat recovery unit, where the steam's energy will be used to
heat the final rinse water.
The most important part of the machine for achieving this balanced air flow is the
drying zone. Here, it is possible to affect the air flow by adjusting the spreader
plate, guide plates and the adjustable deflector plate.
Fan outlet, guide and deflector plates below the washing conveyor (drying zone)
1.
2.
3.
4.
5.
6.
When adjusting the drying zone:
•
•
•
WD-59CTS & WD-66CTS
machine size
type of heating in the dishwasher
conditions in the dishwashing room (ventilation, temperature, etc.)
type of items being washed in the machine
curtain placement etc.
Spreader plate
Guide plates (reversible)
Fan outlet
Deflector plate (non-adjustable)
Guide plate
Deflector plate (adjustable)
the machine must be running,
all curtains in the machine must be in position,
the spreader plates, guide plates and adjustable deflector plate must be
loose but in position, i.e. the screws holding the plates must be tightened
so that the plates are held in position but must not be torque-tightened. It
must be possible to adjust the plates.
25
6
5
Rev. (202210)
4
35-1-02-009
Advertisement
Table of Contents
