Table of Contents
Advertisement
Installation instructions
3.8 Adjusting the locking arms
1.
2.
3.
4.
5.
6.
It is important to adjust the locking arms (1) to avoid the machine from being
started without the gates having been locked.
•
•
•
•
•
WD-18CW
(3). In this position, the rotating table should not be resting on the four
support rollers (2).
Locking arm
Upper gate bar
Circular rod, Ø 6 mm
Sensor plate
Screw
Inductive sensor
Power to the controls needs to be on and the diagnostics mode must be
displayed on the touch panel to make adjustments.
Close the gates.
Pull the locking arm (1) down. When the upper edge of the circular rod (3)
is level with the underside of the upper gate bar (2), the signal on the touch
panel's diagnostics mode is displayed. If the signal is not displayed in this
mode, the sensor plate (4) must be adjusted.
Undo the screw (5) and move the sensor plate (4) up or down. Continually
check whether the touch panel's diagnostics mode is displayed in exactly
the right position by pulling the locking arms down.
If the machine has a two side door, adjust both locking arms.
19
Rev. (202211)
Advertisement
Table of Contents
